Paradyne Comsphere 3920Plus Installation And Operation Manual page 204

COMSPHERE 392xPlus Modems
S-Register
S74 Network Position Identification. Register identifies each modem as either a
control or tributary modem.
Register has the following values:
0 = Tributary
1 = Control
The factory setting is Tributary.
S75 Network Management Address. Register determines the modem's network
address. This address is used when accessing the modem from the 6700
Series NMS.
Enter a value from 0 (network address 001) to 255 (network address 256).
The factory setting is 0.
S76 V.32bis Autorate (Dial Line). Register determines if Autorating is used on dial
lines when connected in V.32bis mode.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
S78 V.32bis Automode (Dial Line). Register allows the modem (when operating on
dial lines) to automatically detect and connect to the remote modem's
modulation scheme.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
S82 V.32bis Autorate (Leased Line). Register determines if Autorating is used on
leased lines when connected in V.32bis mode.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
S84 AT Command Mode. Register determines how the modem responds to valid
and invalid AT commands.
Register has the following values:
0 = Normal
1 = No ERROR
2 = No Strap or ERROR
The factory setting is Normal.
5-24
Table 5-3
(9 of 12)
392x Plus S-Registers
Description
April 1995
DCP LCD
Command
Sequence
Configure\Edit\
Misc
Configure\Edit\
Dial
Configure\Edit\
Dial Line
Configure\Edit\
Dial Line
Configure\Edit\
Leased Line
Configure\Edit\
DTE Dialer
3920-A2-GN31-10