Eia Leds - Paradyne COMSPHERE 3911 Installation And Operation Manual

COMSPHERE 3900 Series Modems
If you want to disable the modem's data stream, press the F2 key. When the message Command
Complete appears, press the
Press the F2 key again to enable the modem's data stream.
To exit this function and remain in the Control branch, press the
the Top-Level menu, press the

EIA LEDs

Use the EIA LEDs function to change the port that controls the front panel LEDs. This function
allows the front panel EIA LEDs to display the activity of a selected digital interface.
To access EIA LEDs from the Control branch, make the following selections:
Press the
Press the F1 key until the appropriate digital interface appears.
The xxxxx field displays the currently selected interface. The valid interfaces are Port1, and
depending on the configuration option, either CC (NMS Control Channel), or DC (Diagnostic
Channel). Refer to Diag Connection in Table 5-8, Miscellaneous Configuration Options, in
Chapter 5, DCP Configuration.
Select the appropriate interface by pressing the corresponding function key.
7-4
key to clear the message.
Data Stream
Port1 Enable
F1 F2 F3
key.
Control:
EIA_LEDs
F3
F1 F2
key until EIA_LEDs appears. Select EIA_LEDs.
EIA_LED : xxxxx
Port1 CC
F3
F1 F2
EIA_LED : xxxxx
Command Complete
F1 F2 F3
September 1998
key. To exit and return to
3910-A2-GN32-40