Paradyne Comsphere 3920Plus Installation And Operation Manual page 187

Comsphere 392 plus series
Hide thumbs Also See for Comsphere 3920Plus:
Table of Contents

Advertisement

AT
Command
DS= n
Dial Stored Number. Dials the number stored in Location n (1–24). (To store a
telephone number, refer to the & Zn=x command.)
E n
Command Character Echo.
E0
Disables echo to the DTE.
E1
Enables echo to the DTE.
H n
Hook Switch Control.
H0
Modem goes on-hook.
H1
Modem goes off-hook.
I n
Identification.
Displays product code — 144.
I0
I
1
Displays 3-digit firmware revision number.
I2
Performs an EPROM check.
L n
Speaker Volume.
L0
Selects low volume.
L1
Selects low volume.
L2
Selects medium volume.
L3
Selects high volume.
M n
Speaker On/Off.
M0
Speaker always OFF.
M1
Speaker ON until carrier signal is detected.
M2
Speaker always ON.
O
Return to Online or Data Mode. Returns modem to Data mode from Online
Command mode.
P
Pulse Dial. Sets the modem for Pulse Dial mode.
NOTE: Pulse Mode is disabled in Denmark and Sweden.
Q n
Result Codes.
Q0
Enables modem to send result codes to the DTE.
Q1
Disables modem from sending result codes to the DTE.
Q2
Enables in Originate mode only for modem to send result codes to
the DTE. Required for most UNIX
S n=r
Change S-Register. Changes contents of S-Register (where n is the S-Register,
and r is the new value).
S n ?
Display S-Register. Displays value of S-Register where n is the S-Register
number.
T
Tone Dial. Sets the modem for tone dial mode.
V n
Result Codes Format.
V0
Displays result codes in Number (1) format (digits).
V1
Displays result codes as text.
V2
Displays result codes in Number (2) format (digits).
3920-A2-GN31-10
Table 5-2
(2 of 9)
392x Plus AT Commands
Description
r
applications.
April 1995
AT Command Set and S-Registers
DCP LCD
Command
Sequence
Call Setup\Dial\
Dial Directory:
Configure\Edit\
DTE Dialer
H0: Call Setup\
Disconnect or
Control\Remove
Make Busy
H1: Control\ Make
Busy
Status\Identity
Control\Speaker
Configure\Edit\
Misc
Control\Speaker
Configure\Edit\
Misc
None
Configure\Edit\
Line Dialer
Configure\Edit\
DTE Dialer
None
None
Configure\Edit\
Line Dialer
Configure\Edit\
DTE Dialer
5-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Comsphere 3921plus

Table of Contents