Paradyne Comsphere 3920Plus Installation And Operation Manual page 47

Status Message
Call Disconnect ATH Disconnect
Bad Lines Disc
No Carrier Disc
DTR Disconnect
EC Disconnect
Inv Rate Disc
LnCurrnt Disc
LongSpace Disc
NoData Disc
Disconnecting
RmtCmnded Disc
Talk Mode
Firmware DownldOnly
Download Result Mode
Frmware
Upgrade
RemClone Failed
Remote Clone
OK
Bcast Clone
Done
AT Command Reset by AT
Reset command
3920-A2-GN31-10
Table 3-3
(3 of 3)
Top-Level Menu Status
The modem has disconnected due to an ATH command.
The modem has disconnected because the lines do not support the
modulation and/or data rate selected.
The modem disconnects due to the loss of carrier signal from the remote
modem.
The modem has disconnected due to the loss of DTR from the DTE.
The modem has disconnected due to failure to negotiate Error Control
mode.
When using V.32bis modulation, the remote modem does not support the
data rate used by the local modem.
The modem has disconnected due to the loss of line current.
The modem has disconnected due to the detection of a long space.
The modem has disconnected due to a lack of transmitted and received
data.
The modem has begun the disconnect sequence.
The modem has disconnected due to a V.32 Cleardown received from the
remote modem.
The modem is in Talk mode.
A local download of firmware or a remote cloning of firmware has failed.
The modem is currently in a Download Only mode in which only another
download attempt is possible.
A local download of firmware or a remote cloning of firmware was
successful.
A remote cloning of firmware has failed. This message appears on the local
modem's LCD.
A remote cloning of firmware was successful. This message appears on the
local modem's LCD.
A broadcast cloning of firmware is complete. Look under the Control branch
for multipoint cloning results. This message appears on the local modem's
LCD.
The modem has performed a reset in response to an ATZ command.
April 1995
Indicates
DCP Operation
3-13