The following sections describe three uses of the Talk/Data function.
Manual Dialing When the Remote Modem is Configured for Auto-Answer
If you are originating a call using a telephone and the remote modem is configured for
Auto-Answer, perform the following procedure.
Press the
Lift the attached handset and dial the telephone number of the remote modem. When the remote
modem answers, it transmits an answer tone.
When you hear this tone, immediately select Tlk/Data and hang up the handset. This starts the
handshaking sequence between your modem and the remote modem.
If this is successful, the modems are in Data mode and OnLine appears on the LCD.
3910-A2-GN32-30
On the remote modem, the Line Current Disconnect configuration
option (refer to the Line Dialer section in Chapter 4) must be set to
Disable.
This configuration option does not appear on Models 3910-A1-401
and 3911-B1-001.
Idle:19.2
Tlk/Data
F1
F2
F3
key until Tlk/Data appears.
Idle:19.2
Tlk/Data
F3
F1
F2
Online:19.2
Call_Setup
F1
F2
F3
November 1996
NOTE
>
DCP Operation
3-63