Key Mapping - Aastra 9143i Series Administrator's Manual

IP Phone Administrator Guide
Operational Features

Key Mapping

There are hard keys on your phone, such as Hold, Redial, Xfer, and Conf that are
configured by default for specific call-handling features. (See the product-specific
User Guide for more information about these key functions.
Enabling/Disabling Redial, Xfer, and Conf Keys
You can enable or disable the Redial, Xfer, and Conf keys as required using the
following parameters in the configuration files:
• redial disabled
• conference disabled
• call transfer disabled
Valid values for this parameter are 0 (enabled) and 1 (disabled).
If this parameter is set to 1, the key is not active and is ignored if pressed by the
user. For "redial disabled" the value of 1 does not save the dialed number to the
"Redial List".
If this parameter is set to 0, the key is active and can be pressed by the user.
This feature is configurable via the configuration files only.
5-114
Notes:
1. On 8 and 11-Line LCD phones, the Xfer and Conf
keys are hard-coded by default on keys 5 and 6 to the left of the
LCD display and cannot be reassigned. The Xfer and Conf labels
display when you lift the handset. To disable these keys, see
"Enabling/Disabling Redial, Xfer, and Conf Keys"
2. On the 3-Line LCD phones, the Xfer and Conf keys are
assigned by default to available keys, respectively. These keys are
programmable keys and can be reassigned if applicable. To disable
these keys, see "Enabling/Disabling Redial, Xfer, and Conf Keys"
on page 5-114.
on page
41-001160-03 Rev 00, Release 2.5
5-114.