Aastra 9143i Series Administrator's Manual page 399

• Custom mode - The Custom mode allows you to configure CFWD for a
specific account or all accounts. You can configure a specific mode (All,
Busy, and/or No Answer) for each account independently or all accounts. On
the 3-line LCD phones, you can set all accounts to ALL On or ALL Off. On
the 8 and 11-Line LCD phones, you can set all accounts to All On, All Off, or
copy the configuration for the account in focus to all other accounts using a
CopytoAll softkey.
The states you can set for Call Forward are All, Busy, No Answer. You can enable
different call forwarding rules/modes independently (for example, you can set
different phone numbers for Busy, All, and NoAns modes and then turn them on/
off individually. The behavior of these states is dependent on the mode (account,
phone, or custom) you configure on the phone.
Reference
For more information about how Call Forwarding works and how you can use it
on the IP Phones, see
Configuring Call Forward Key Mode
Use the following procedures to set the Call Forward key mode on the IP phones.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Key Mode Settings" on
41-001160-03 Rev 00, Release 2.5
Note: If there is only one account configured on the phone, then the
mode setting is ignored and the phone behaves as if the mode was set
to "Phone".
"Call Forwarding"
page A-148.
Configuring Operational Features
Operational Features
on page 5-249.
"Call Forward
5-95