Aastra 9143i Series Administrator's Manual page 244

IP Phone Administrator Guide
Network Settings
Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Area Network (VLAN) Settings"
IP Phone UI
Step Action
1 Press on the phone to enter the Options List.
2 Select Administrator Menu.
3 Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4 Select Network Settings.
5 Select VLAN Settings.
To globally enable/disable VLAN and set priority for non-IP packets:
6 Select VLAN Enable.
7 Press Change to set VLAN Enable to "Yes" to enable or "No" to disable. Default is "No".
8 Press Done to save the changes.
9 Select Phone VLAN.
10 Select VLAN Priority.
11 Select Other and enter a non-IP priority value from 0 to 7 for non-IP packets.
Default for this field is 5.
4-60
Notes:
1. VLAN is disabled by default. When you enable VLAN, the IP
phones use the default settings for each VLAN parameter. You can
change the default settings if required using the following procedure.
2. PC Port parameters are not applicable to the 6730i IP Phone.
on page A-42.
"Virtual Local
41-001160-03 Rev 00, Release 2.5