Status Code On Ignoring Incoming Calls - Aastra 9143i Series Administrator's Manual

IP Phone Administrator Guide
Operational, Basic, and Advanced Parameters
Description (Cont'd)
Format
Default Value
Range
Example

Status Code on Ignoring Incoming Calls

Parameter –
sip ignore status code
Description
Format
Default Value
Range
Example
A-168
Transfer/Conference Call Behavior
If you are dialing the phone to transfer or conference a call, and your
phone receives an incoming call, your dialing is never interrupted
(regardless of whether the "Incoming Call Interrupts Dialing" is enabled or
disabled). For Transfer and Conference, the incoming calls always go to
an available line (other than the one you are using for dialing) and the
incoming call's line LED blinks. The LCD still displays your dialing screen.
Intercom Behavior
If "Incoming Call Interrupts Dialing" (or incoming call cancels dialing
in config files) is enabled and you are dialing an outgoing Intercom call,
the enabled interrupt setting takes precedence over an enabled "Allow
Barge In" setting. The incoming call interrupts your dialing on an outgoing
intercom call. On an incoming intercom call, the enabled "Allow Barge
In" and "Auto-Answer" occurs while you are dialing to transfer or
conference the call. However, the incoming call goes to an available idle
line, and the LED blinks while you are dialing the second half of the
conference or transfer.
If "Incoming Call Interrupts Dialing" (or incoming call cancels dialing
in config files) is disabled, an incoming intercom goes to an available idle
line and the LED blinks for that line. The phone answers the call under all
conditions.
Boolean
0 (disable)
0 (disable)
1 (enable)
incoming call cancels dialing: 1
Configuration Files
Specifies the status code that is sent in the response to the server when
a user ignores an incoming call.
Integer
486
Valid SIP final negative response code (Refer to RFC3261)
sip ignore status code: 486
aastra.cfg, <mac>.cfg
41-001160-03 Rev 00, Release 2.5