Aastra 9143i Series Administrator's Manual page 240

IP Phone Administrator Guide
Network Settings
DSCP Range/VLAN Priority Mapping
DSCP bits in the ToS field of the IP header are set for RTP, RTCP, and SIP packets
using either the default values or the values configured via the "tos sip", "tos rtp",
and "tos rtcp" parameters.
When the VLAN global configuration parameter, "tagging enabled" is set to 1,
VLAN priority for IP packets is mapped to the DSCP value instead of a single
priority for all packets. An administrator can also configure VLAN priority for
non-IP packets using the "priority non-ip" parameter.
Since the default DSCP settings for SIP, RTP, and RTCP are 26, 46, and 46
respectively, this results in corresponding default VLAN priorities of 3 for SIP, 4
for RTP, and 4 for RTCP (based on the settings in the table
Priority"
You can change the default parameters by modifying just the DSCP values, just
the VLAN priority values, or by modifying all values.
The following table shows the DSCP range/VLAN priority mapping.
DSCP Range/VLAN Priority
4-56
on page 4-56).
DSCP
Range
0-7
8-15
16-23
24-31
32-39
40-47
48-55
56-63
VLAN Priority
0
1
2
3
4
5
6
7
41-001160-03 Rev 00, Release 2.5
"DSCP Range/VLAN