Switch Focus To Ringing Line - Aastra 9143i Series Administrator's Manual

Switch Focus to Ringing Line

An Administrator or User can control the behavior of the phone when it receives
an incoming call when it is already in a connected call. By default, the phone
switches focus to the ringing line to enable the user to see who is calling them.
You can turn off this functionality so that the phone now stays focused on the
connected call. You can do this using the "switch focus to ringing line"
parameter in the configuration files or the Aastra Web UI.
Configuring "Switch Focus to Ringing Line"
You use the following procedures to enable or disable "Switch Focus to Ringing
Line".
Configuration Files
For specific parameters you can set in the configuration files for enabling disabling "Switch Focus to Ringing
Line", see Appendix A, the section,
41-001160-03 Rev 00, Release 2.5
Note: If you configure the BLF/Xfer key(s) and/or Speeddial/Xfer
key(s) on the phone, you can enable or disable the switching of the
user interface focus to ringing line while the phone is in the connected
state.
"Switch Focus to Ringing Line"
Configuring Operational Features
Operational Features
on page A-169.
5-79