Aastra 9143i Series Administrator's Manual page 645

Action URI Disconnected
The phones have a parameter, "action uri disconnected" that allow a disconnect
event to occur when the phone transitions from any active state (outgoing,
incoming, connected, or calling) to an idle state. This parameter can use the
variable "$$LINESTATE$$".
If the Administrator enables this feature (by specifying a disconnect URI),
when a call is disconnected, the phone
Disconnect URI configured. If the phones finds a configured URI with a
$$LINESTATE$$ variable, it replaces the $$LINESTATE$$ variable with the
appropriate line state of the current active line. After all of the variables are
bound, the phone executes a GET on the URI. The following table lists the
applicable values for the $$LINESTATE$$ variable.
$$LINESTATE$$ Value Description
IDLE
DIALING
CALLING
OUTGOING
INCOMING
CONNECTED
CLEARING
The Action URI Disconnect feature allows an Administrator to determine the
reason for the disconnect if required.
41-001160-03 Rev 00, Release 2.5
Note: The $$LINESTATE$$ variable is optional and not required when
enabling the "action uri disconnected" parameter.
Phone is idle.
Phone is offhook and ready to dial.
A SIP INVITE was sent but no response
was received.
Remote party is ringing.
Local phone is ringing.
Parties are talking.
Call was released but not acknowledged.
Note: If you enable the Action URI Disconnect feature by specifying a
URI, the URI is called when any disconnect event occurs including an
intercom call or a conference setup.
Configuring Operational Features
Operational Features
checks to see if the event has a
Meaning in a Disconnected URI
N/A
N/A
Error occurred during the call.
Call was cancelled.
Call was missed or cancelled.
Call was successful.
N/A
5-341