Mechanical Adjustment; Adjustment Of The Tray Volume - Konica Minolta bizhub C350 Service Manual

Mechanical adjustment

4. Mechanical adjustment
4.1

Adjustment of the tray volume

• Read out the value of maximum width and minimum width of the document width detec-
tion volume interlocked with the Document Take-up Tray Edge Guide.
1. Set the mode to the Tech. Rep. Mode.
2. Touch "ADF Check".
3. Touch "Tray Width Adjust".
A. Adjustment procedure
3-6
DF-601 Field Service Ver2.0 Sep. 2004
1. Widen the width across the edge
guides [1] by sliding them to their
maximum width.
2. Touch "Max. Width".
[1]
4582fs3504c0
3. Press the "Start" key. Confirm that
the Result is "OK".
4582fs3530e0
4. Narrow the width across the edge
guides [2] by sliding them to their
minimum width.
[2]
4582fs3506c0
5. Touch "Min. Width".
6. Press the "Start" key. Confirm that
the Result is "OK".
7. Touch "END".
8. Touch "Fin. Time" on the Tech. Rep.
Mode screen.
If the Result is "NG":
4582fs3531e0
• Possible causes includes failure of the
document width detection volume,
wrong wiring to the volume and failure
of the PWB-CONT.