Image Transfer Belt Unit - Konica Minolta bizhub C350 Service Manual

bizhub C350 Field Service Ver2.0 Sep. 2004
1.5.23

Image Transfer Belt Unit

B. Replacing Procedure
NOTES
• If a Finishing Option is installed, remove if from the main unit before trying to
replace the Transfer Belt Assembly.
• When removing the Finishing Option, support the horizontal transport unit with
your hand to prevent if from dropping.
1. Turn OFF the main switch.
2. Slide out the IU (C/M/Y/Bk).
NOTE
• After the Imaging Unit has been removed from the main unit, be sure to place it in
the plastic bag (black) or wrap it in a light shielding cloth, and store it in a dark
place.
Do not leave the Imaging Unit exposed to light for a extended period of time, as it
may become damaged.
[1]
[2]
A. Cleaning Procedure
1. Remove the Image Transfer Belt
Unit.
☞ 2-23
2. Using a dried soft cloth, wipe the
Transfer belt.
NOTES
• If it is difficult to clean with dried
4036fs2154c0
soft cloth, dampen a soft cloth with
a solvent.
• Do not wipe out with water.
• When solvent is used to dampen a
cloth, do not use the ones other
than shown below: isopropyl alco-
hol, ethyl alcohol, PPC Cleaner, Sol
mix AP-7
• After cleaned with the solvent,
make copies more than 28-piece of
A3 white paper to eliminate the
image noise.
3. Open the Right Door.
4. Remove two Screws [1] and release
the Lock of the Image Transfer Belt
Unit [2].
4036fs2155c0
Periodical check
2-23