Konica Minolta bizhub C350 Service Manual page 182

bizhub C350 Field Service Ver2.0 Sep. 2004
B. Left Margin
Functions • To vary the print start position in the CD direction for each paper source.
Use • The LPH Unit has been replaced.
• A paper feed unit has been added.
• The image on the copy deviates in the CD direction.
Adjustment
Width A
Specification
Adjustment If width A is longer than the specifications, make the setting value smaller than the cur-
Instructions rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
1. Touch "Machine Adjust" → "PRT Area" → "Left Margin."
Adjustment
Procedure 2. Press the Start key to let the machine produce a test pattern.
3. Check the dimension of width A on the test pattern.
4. If width A falls outside the specified range, change the setting using the Up/Down
key.
5. Press the Start key to let the machine produce a test pattern.
6. Check the dimension of width A on the test pattern.
7. If width A is outside the specified range, change the setting again and make a check
again.
8. If width A falls within the specified range, touch "END"
9. Following the same procedure, adjust for all other paper sources. (Use A4 or 8 1/2 ×
11 plain paper for the Bypass.)
Width A on the test pattern produced should
fall within the following range.
Specifications : 3.0 ± 0.5 mm
Setting Range: -3.0 mm to +3.0 mm
4036fs3010c0
TECH. REP. MODE
(in 0.2 mm increments)
3-47