Adjustment Of The Folding Position; Df-601-Equipped Machine - Konica Minolta bizhub C350 Service Manual

Mechanical adjustment
3.2

Adjustment of the folding position

• The folding position is adjusted by aligning the folding position to the stapling position.
• This adjustment is made in the Tech. Rep. Mode of the main unit. Since the adjustment is
made in increments of 1 mm, this adjustment is useful for eliminating a displacement of
1mm or more.
• For the effective adjustment of a minimal displacement smaller than 1 mm, refer to
"Board switch".
Adjustment range: - 7 to + 7 mm (Increment: 1 mm)
3.2.1

DF-601-equipped machine

1. Return to the basic screen.
2. Select the functions as follows: Orig
3. Set five sheets of A3 or 11 x 17 original (blank paper acceptable) in the Original Tray.
• These five sheets are used for adjustment to minimize variation.
4. Press the "Start" Key.
5. Set the mode to the Tech. Rep. Mode.
6. Touch "Machine Adjust".
7. Touch "Center Binding Position".
1
9. Check the finished copies for deviation of the stapling position of from the newly folded
position.
Take the top surface of the finished copies as "A", and the under surface as "B".
3-6
FS-601 Field Service Ver2.0 Sep. 2004
→
Copy 4in1/Booklet
8. Touch "Fold-Position".
4583fs3525e0
→ →
Booklet Bind.
4583fs3523e1