Konica Minolta bizhub C350 Service Manual page 463

Mechanical adjustment
13. Perform another test print and check the reference deviation.
14. Repeat the adjustment until the reference line falls within the specified range.
15. Tighten the adjustment screw.
16. Repeat steps 1 to 15 similarly for the tray4.
3-4
A
4348fs3509c0
[2]
[1]
4348fs3601c0
[4]
[3]
4348fs3602c0
PC-101/PC-201 Field Service Ver2.0 Sep. 2004
7. Measure the width of printed refer-
ence line A.
Specification: 3.0 mm
8. If the measured width A falls outside
the specified range, enter the correc-
tion value.
9. Produce another test print and check
to see if width A falls within the spec-
ified range.
• If adjustment cannot be completed
only by inputting numeric value,
perform adjustment according to
the following procedure.
10. Slide out the drawer [1] and unload
paper from it.
11. Loosen three screws [2] at the center
of the Paper Lifting Plate.
12. Watching the graduations [3] pro-
vided in the drawer, move the Edge
Guide [4] in the rear.
• If width A is greater than the specified
value, move the Edge Guide toward
the front.
• If width A is smaller than the specified
value, move the Edge Guide toward
the rear.
1.0 mm
±