Procedure After Replacing The Eep-Rom (Ic1002); Punch Center Position Adjustment - Konica Minolta bizhub C350 Service Manual

FS-601 Field Service Ver2.0 Sep. 2004
4.2.3

Procedure after replacing the EEP-ROM (IC1002)

ON
1
4.2.4

Punch center position adjustment

• This adjustment is made when the Punch lateral movement is changed from the lateral
registration motion (automatic through end face detection) to fixed system based on the
paper size.
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
2 3 4
4583fs3517c0
5 6 7 8
4583fs3523c0
5 6 7 8
4583fs3524c0
5 6 7 8
4583fs3525c0
1. Turn OFF the Power switch of the
main unit.
2. Set the bits 1 through 4 of
DIPSW1001 on the Punch Control
Board as shown on the Left fig-
ure.Press SW1002 and SW1003 on
the Punch Control Board simulta-
neously.
• This will initialize the EEP-ROM. After
the initialization, all LED1001,
LED1002 and LED1003 light up.
3. Adjust the sensor output, and regis-
ter the number of punch holes.
4. Set all bits of DIP SW 1001 to OFF.
1. Turn OFF the Power Switch of the
main unit.
2. Remove the Rear Cover.
☞ 2-3
3. Check that all keys of SW1 of the
Finisher Control Board are OFF.
4. Turn ON the Power Switch of the
main unit and wait until the Finisher
completes its initial operation.
• Use the following procedure to clear
the adjustment of the Punch lateral
movement.
5. Turn ON keys 4, 5, 6, and 7 of SW1
of the Finisher Control Board.
6. Turn ON key 1 of SW1 of the Fin-
isher Control Board.
7. Press PSW1 and PSW2 of the
Finisher Control Board at the same
time.
Board switch
3-15