Configuring The Communication Mode Manually - Oce CS2436 User Manual

Network Setting (CS2436-9)
9. 1. 12.
Network Setting > Network Setting >

Configuring the Communication Mode Manually

This topic gives instructions for configuring the communication mode manually.
1.
On the Tab Selection screen of the Control Panel, press
Adj. tab (
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press
4.
Press
5.
Press
6.
Press
The display reverts to the Ethernet Driver menu.
7.
Press
8.
Press
The display reverts to the Ethernet Driver menu.
9.
Press
10.
Press
The display reverts to the Ethernet Driver menu.
11.
Press
12.
Press
The display reverts to the Ethernet Driver menu.
13.
Press the Menu button.
After the confirmation message is displayed, press the OK button.
The new settings will take effect after the printer restarts.
).
Note
If the Tab Selection screen is not displayed, press the Menu
button.
to select Interface Setup, and then press the OK button.
or
to select Ethernet Driver, and then press the OK button.
or
to select Auto Detect, and then press the OK button.
or
or to select Off, and then press the OK button.
to select Comm.Mode, and then press the OK button.
or
or to select the communication mode, and then press the OK button.
to select Ethernet Type, and then press the OK button.
or
or to select the Ethernet type, and then press the OK button.
to select Spanning Tree, and then press the OK button.
or
or to enable or disable spanning tree support, and then press the OK button.
or to select the Settings/