Oce CS2436 User Manual page 530

Printer Parts (CS2436-8)
Adj. Fine Feed
Head Cleaning
Nozzle Check
Maintenance
Replace P.head
Repl. maint cart
Head Info
GL2 Replot
GL2 BufferClear
Adjust
Length
Change Settings
Monochrome
Color (CAD) 1
Color (CAD) 2
B:
Standard/
Draft
Displayed when you have selected
Feed Priority >Adj. Priority >Print
A:High
Length.
Adjustment relative to the amount of
stretching or shrinkage of the current
paper.
Enter either the adjustment results
from AdjustmentPrint or the
discrepancy that you measured (as a
B:
percentage).
Standard/
For paper that tends to stretch,
Draft
increase the feed amount by choosing
a higher adjustment value. For paper
that tends to shrink, decrease the
feed amount by choosing a lower
adjustment value.
Displayed when you have selected
Feed Priority >Adj. Priority
>Automatic or Print Quality. Fine-
tune the feed amount manually during
printing. (See "Fine-Tuning the Paper
Feed Amount (Adj. Fine
Feed) (7.2.5).")
Clean the Printhead. (See "Cleaning
the Printhead (10.2.3).")
Choose Head Cleaning A if printing
is faint, oddly colored, or contains
foreign substances.
Choose Head Cleaning B if no ink is
printed at all, or if printing is not
improved by Head Cleaning A.
Print a test pattern to check the
nozzles.
When replacing the Printhead, choose
Yes and follow the instructions on the
screen. (See "Replacing the
Printhead (10.2.4).")
Not displayed during a warning
message that the remaining
Maintenance Cartridge capacity is low.
When replacing the Maintenance
Cartridge, choose Yes and follow the
instructions on the screen. (See
"Replacing the Maintenance
Cartridge (10.3.2).")
Indicates information about the
printhead.
Print the previous GL2 print job again.
Clear the print data in the replot
buffer.
Print in monochrome.
Print in standard colors.
Print in brighter colors.