Manual Banding Adjustment (Adj. Quality) - Oce CS2436 User Manual

Adjustments for Better Print Quality (CS2436-7)
7. 2. 3.
Adjustments for Better Print Quality > Adjusting the feed amount >

Manual Banding Adjustment (Adj. Quality)

If printed images are affected by banding in different colors, execute Adj. Quality for adjustment
of the paper feed amount.
Use Manual adjustment with highly transparent media or other paper for which Auto
(GenuinePpr) or Auto(OtherPaper) cannot be used.
(See "Automatic Banding Adjustment (Adj. Quality) (7.2.3).")
Manual adjustment requires you to enter an adjustment value after a test pattern is printed.
Note
Always check the Adj. Priority values before using Manual adjustment.
(See "Selecting a Feed Amount Adjustment Method (Feed Priority) (7.2.2).")
If additional fine-tuning is necessary after Manual adjustment, use Adj.
Fine Feed
(See "Fine-Tuning the Paper Feed Amount (Adj. Fine Feed) (7.2.5).")
Use Adjust Length to ensure that lines in CAD drawings are printed at
exactly the right length.
(See "Adjusting Line Length (Adjust Length) (7.2.6).")
Use paper of the same type and size for adjustment as you will use for
printing.
Paper to Prepare
Rolls
Sheets
Perform adjustment as follows.
1.
Load the paper.
Attaching the Roll Holder to Rolls (6.2.1)
●
Loading Rolls in the Printer (6.2.2)
●
Loading Sheets in the Printer (6.3.1)
●
An unused roll at least 10 inches wide
Two sheets of unused paper of at least A4/Letter size
Note
Always make sure the loaded paper matches the type of paper
specified. Adjustment cannot be completed correctly unless the loaded
paper matches the settings.