Oce CS2436 User Manual page 567

Network Setting (CS2436-9)
If you specify to configure the IP address using DHCP, BOOTP, or RARP,
there must be a server that supports such protocol running in the network.
If you specify to configure the IP address using DHCP, BOOTP, or RARP,
the IP address obtained by this method is used first. If you cannot obtain the
IP address, the address specified in IP Address is used.
It takes up to two minutes to determine whether DHCP, BOOTP, or RARP
are available. We recommend clearing check boxes of options you will not use.
If you are using a DNS server, select Enable DNS Dynamic Update and
enter the IP Address for DNS servers, DNS host name, and DNS domain
name in Primary DNS Server Address, Secondary DNS Server
Address, DNS Host Name, and DNS Domain Name, respectively.
When using an IPv6 IP address
1.
Start the web browser and enter the following URL in the Location (or Address ) box to
display the RemoteUI page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2.
Select Administrator Mode and click Logon.
3.
If a password has been set on the printer, enter the password.
4.
Click Network in the Device Manager menu at left to display the Network page.
5.
Click Edit in the upper-right corner of the TCP/IPv6 group to display the Edit TCP/IP
Protocol Settings page.
6.
Refer to the TCP/IP Settings Items table to complete the settings.
TCP/IP Settings Items
Item
Use IPv6
Use DHCPv6
Use a stateless
address
Use a manual
address
Details
Activate to enable
IPv6.
Activate when using a
DHCP server to
acquire the IP address.
Activate when using
an IPv6-compatible
router to acquire the
IP address.
Activate when
configuring the IP
address manually.
Default Setting
Off
Off
On
Off