Adjustments for Better Print Quality (CS2436-7)
7. 2. 5.
Adjustments for Better Print Quality > Adjusting the feed amount >
Adjusting Line Length (Adjust Length)
To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length
to adjust the amount that paper is advanced.
There are two options in Adjust Length : AdjustmentPrint and Change Settings.
AdjustmentPrint
●
After a test pattern is printed, you will measure the discrepancy based on the results of
printing.
Change Settings
●
No test pattern is printed. Instead, you will measure a document already printed to
determine the discrepancy.
Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High
or B:Standard/Draft. Choose the mode that suits your particular printing application.
A:High
●
This setting is applied when Highest or High is selected in Print Quality in the printer
driver.
B:Standard/Draft
●
This setting is applied when Standard or Draft is selected in Print Quality in the printer
driver.
Note
Always check the Adj. Priority values before using Adjust Length. (See
"Selecting a Feed Amount Adjustment Method (Feed Priority) (7.2.2).")
Use paper of the same type and size for adjustment as you will use for
printing.
Paper to Prepare
Rolls
Sheets
Perform adjustment as follows.
1.
Load the paper.
Attaching the Roll Holder to Rolls (6.2.1)
●
An unused roll at least 10 inches wide
High-precision ruler
One sheet of unused paper of at least A4/Letter size
High-precision ruler