Specifying The Printer's Frame Type - Oce CS2436 User Manual

Network Setting (CS2436-9)
9. 2. 4.
Network Setting > Network Setting (Windows) >

Specifying the Printer's Frame Type

To enable communication between the printer and computers on your network, specify the
Ethernet frame type in your NetWare environment.
Follow these steps to specify the frame type by using Device Setup Utility or the printer Control
Panel.
Note
You can specify the frame type by using RemoteUI if the printer's IP
address is configured.
Important
Before specifying the frame type, make sure the printer is on and
connected to the network.
For instructions on installing Device Setup Utility, see "Installing Device
Setup Utility (9.2.8)."
Specifying the frame type using Device Setup Utility
1.
Start Device Setup Utility.
2.
In the list of printers, select the printer to configure.
3.
Choose Protocol Settings from the Printer menu.
4.
Click the NetWare tab and select the frame type in the NetWare Frame Type list.
5.
Click the IPv4 tab and select ETHERNET II in the Frame Type list.
6.
In IP Address, enter the IP address assigned to the printer, and then enter the subnet
mask in Subnet Mask and the default gateway in Gateway Address.
7.
Click Set.
8.
Click OK after the Confirmation message is displayed.
9.
Exit Device Setup Utility.
Specifying the frame type using the printer Control Panel
Important
You must specify the IP address here to be able to configure
NetWare protocol settings using RemoteUI.