Oce CS2436 User Manual page 454

Handling Paper (CS2436-6)
6. 3. 2.
Handling Paper > Handling sheets >
Changing the Type of Paper
Follow these steps to change the type of paper specified on the printer after you have loaded paper.
If you will continue using this type of paper later, selecting Keep Paper Type >On will save the time and effort
of configuring the media type setting when you load the paper again. The current media type settings before you
select On will be automatically selected at that time. (See
Important
For best printing results, the printer fine-tunes the feed amount for each type of paper.
Be sure to select the type of paper to use correctly before printing.
Because the printer fine-tunes the feed amount for each type of paper, the margins and
the size of printed images may vary depending on the type of paper used. If margins and
the size of images are not as you expected, adjust the paper feed amount.
(See "Adjusting the Feed Amount (7.2.1).")
Changing the Type of Paper
Note
After you load a roll, the printer automatically shows a menu for selection of the type of
paper on the Display Screen. Select the type of paper and press the OK button.
If no barcode has been printed on the roll and you have set ManageRemainRoll to On,
specify the roll length after the type of paper. (See "Specifying the Paper Length (6.2.4).")
1.
On the Tab Selection screen of the Control Panel, press
Note
2.
Press the OK button.
The Paper Menu is displayed.
3.
Press or
4.
Press or
button.
5.
Press or
Note
If the Tab Selection screen is not displayed, press the Menu button.
to select Chg. Paper Type, and then press the OK button.
to select the type of paper loaded ( Roll Paper or Cut Sheet ), and then press the OK
to select the type of paper loaded in the printer, and then press the OK button.
"Using the Same Type of Paper
or to select the Paper tab (
Regularly.")
).