Printing From A Desired Starting Point - Oce CS2436 User Manual

Handling Paper (CS2436-6)
6. 2. 5.
Handling Paper > Handling rolls >

Printing From a Desired Starting Point

When printing inside boundaries or in other situations when you want to specify a particular position to start
printing from, set Width Detection to Off in the printer menu for the type of paper used.
Set Width Detection to Off
1.
On the Tab Selection screen of the Control Panel, press
Note
2. Press the OK button.
The Paper Menu is displayed.
3.
Press or
4.
Press or
5.
Press or
6.
Press or
Load paper in the desired position to start printing from
Follow these instructions to load paper at the desired starting position for printing when Width Detection is Off.
1.
If you did not send a print job in advance, a menu for selection of the type of paper is displayed.
Press or
Note
2.
"Width Detection OFF. OK to continue?" is now shown on the Display Screen. Press
"Leave OFF", and then press the OK button.
3.
After a menu for selection of the paper size is displayed, press
press the OK button.
4.
Open the Top Cover and check the position where paper is loaded.
If the Tab Selection screen is not displayed, press the Menu button.
to select Paper Details, and then press the OK button.
to select the type of paper, and then press the OK button.
to select Width Detection, and then press the OK button.
to select Off, and then press the OK button.
to select the type of paper, and then press the OK button.
If a print job was received before paper was advanced, the media type and size
specified by the job are shown on the Display Screen.
Thus, this screen is not displayed. Go to step 2.
or to select the Paper tab (
or to select the paper size, and then
).
or to select