Cutting The Leading Edge Of Roll Paper Automatically - Oce CS2436 User Manual

Handling Paper (CS2436-6)
6. 2. 14.
Handling Paper > Handling rolls >

Cutting the Leading Edge of Roll Paper Automatically

If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this
case, set Trim Edge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut
the leading edge to make the edge straight after you load a roll.
Trim Edge First offers the following options.
Automatic
●
If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or
more when you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge,
and scraps are removed. The edge is not cut if the unevenness is less than 3 mm. However, paper may
sometimes be cut, depending on the state of the leading edge.
Off
●
The edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default.
For more information (See "Types of Paper (6.1.1).")
On
●
The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from
the leading edge varies depending on the type of paper. For more information (See "Types of
Paper (6.1.1).")
Follow these steps to change the Trim Edge First setting.
1.
On the Tab Selection screen of the Control Panel, press
Note
If the Tab Selection screen is not displayed, press the Menu button.
or to select the Paper tab ( ).