Oce CS2436 User Manual page 592

Network Setting (CS2436-9)
In remote printer mode, the printer is controlled by the NetWare print server.
Thus, a NetWare print server is required. In NDS remote printer mode (NPrinter),
the NDS print server is used for printing, and in bindery remote printer mode
(RPrinter), the bindery print server is used for printing.
Using NWADMIN or PCONSOLE to set up the print server
Use NWADMIN to set up the print server if NDS queue server mode or remote printer mode is
used.
1.
Log into NetWare as Administrator or with equivalent rights, and then start NWADMIN.
2.
Run Quick Setup.
1.
Choose Print Services Quick Setup in the Tools menu.
2.
Enter a desired name in Print Server Name. To use an existing print server, click
the button at right and choose the name from the list.
3.
Enter a desired printer name in Name.
4.
To use the printer in queue server mode, choose Other/Unknown in Type. To
use the printer in remote printer mode, choose Parallel in Type, click
Communications, and set Ports to LPT1 and Connection Type to Manual
Load.
5.
Enter a desired queue name in Name.
6.
In Volume, enter the volume object (that is, the object representing the physical
volume on the network) where the print queue will be created. Click the button at
right to choose from a list.
7.
Complete other settings as needed and click OK.
Note
3.
Set a password.
1.
Right-click the print server created in step 2 and choose Details.
2.
Click Change Password to open the password input dialog box. Enter the
password.
3.
Click OK to close the password input dialog box.
4.
Click OK or Cancel to close the details dialog box.
4.
To use the printer in remote printer mode, start the print server.
The print server name will be required when configuring the printer's
protocol settings. Write down the print server name for future
reference.
When running Quick Setup, the printer is assigned printer number 0.
When using the printer in queue server mode, do not change the
printer number from 0.