Sc Error Codes; Summary Of Error Levels; Out-Of-Range Temperature Errors - Ricoh Toscana-P1 J007 Service Manual

SC Error Codes

Summary of Error Levels

Level
The printer is damaged or disabled, and the printer
cannot operate. Even after removing the cause of the
A
problem, turning the printer off and on does not solve
the problem.
An abnormal condition exists in the printer, and the
printer cannot operate until the problem is corrected.
Once the operator removes the cause of the problem,
turning the printer off and on should restore the printer
B
to normal operation.
The printer can continue to print, but if the problem is
not corrected soon the printer will no longer be able to
C
operate. The operator must correct the problem as soon
as possible.

Out-of-Range Temperature Errors

Power ON Power to the printer turns on, and
printer enters and remains in
standby mode.
During Printing Printer halts printing and enters
the standby mode.
Make sure that the room temperature is within the allowed range 10°C to 32°C (50°F to 89.6°F) with
Rh 15% to 80%. For more, see Section "1. Installation".
Definition
Printer Status at Error
Typical Errors
SC Error Code.
This is a Service Call Error.
Cover open.
Paper jams.
Ink cartridge out.
Ink cartridge missing.
Ink cartridge installed incorrectly.
Paper size error.
Ink near end.
Ink collection tank near full.
Status After Error
As soon as the temperature of the print heads
reaches the operational temperature range, the
printer enters the "Ready" mode.
The printer remains in the "Standby" mode. The
operator must switch the printer off and on again
to restore normal operation.
SC Error Codes
4
99