Ricoh Toscana-P1 J007 Service Manual page 33

1. Installation
• Make sure the power cord is not coiled or wrapped around any object such as a table or desk leg.
• Never coil the power cord around itself to make it shorter. This can cause the cord to overheat and
cause a fire.
1
• Never handle the power cord with wet hands.
1. Remove the orange tape from around the power cord.
2. Plug the power cord into the power source.
3. Ground the power cord at the power source with the ground wire attached to the plug.
4. Press the [Power] key.
• The printer starts feeding ink into the ink tanks.
• Two alternating messages are displayed with a progress bar to keep you informed about the
progress of ink filling.
• Filling the ink tanks requires about 6 to 10 minutes.
• Do not use the printer or touch any key on the operation panel until you see the "Ready" message
on the operation panel display.
• As soon as the "Ready" message is displayed, the Power lamp lights and remains on.
• Never switch off the printer or disconnect the power cord while the tanks in the print head are
being filled for the first time.
• If you accidentally turn the printer off while the ink tanks are filling, the printer will dump the ink
and empty the tanks. The next time the printer is turned on, it will display the 'ink out' alert
• You might hear a clicking sound while the ink tanks are filling. This is normal and the noise will
stop after a few minutes.
32