Ricoh Toscana-P1 J007 Service Manual page 156

during duplex printing in High Quality mode. This SP setting is linked to the charge pitch tables
(SP1200 to SP1231). The IDs are determined by the temperature and humidity. There are 4
IDs associated with the SP numbers listed below:
• SP1156: ID1
• SP1158: ID2
• SP1160: ID3
• SP1162: ID4
[0 to 255/0/1/0.1 mm]
1157 CHG:W2:EDGE:13
1159 CHG:W2:EDGE:14
1161 CHG:W2:EDGE:15
1163 CHG:W1:EDGE:16
Use this SP to set the pitch width of the charge applied to the MID area on the 2nd side of glossy
paper for duplex printing in the High Quality mode. Do this SP when mist build-up in the MID
area on the 2nd side of glossy paper is causing the print heads to clog during duplex printing
in High Quality mode. This SP setting is linked to the charge pitch tables (SP1200 to SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs associated with the
SP numbers listed below:
• SP1157: ID1
• SP1159: ID2
• SP1161: ID3
• SP1163: ID4
[0 to 255/0/1/0.1 mm]
Calibrate Humidity/Temperature for Duplex
1164 HUMI:B
Use this SP to calibrate the temperature/humidity sensor for humidity readings during duplex
printing. Do this SP to update the charge pitch table for duplex printing. This SP setting is linked
to the humidity steps in the charge pitch tables (SP1200 to SP1231).
[-128 to +127/0/1/0.1%]
1165 TEMP:B
MID: Mj4: ID1
MID: Mj4: ID2
MID: Mj4: ID3
MID: Mj4: ID4
Calibrate Humidity Setting for Duplex
Calibrate Temperature Setting for Duplex
SP Tables
5
155