Ricoh Toscana-P1 J007 Service Manual page 102

The temperature of the DRV board (driver board)
is out of range.
98 A Print head Temperature Sensor Abnormal J011
5
Print head temperature sensor was detected as
abnormal when the printer was turned on.
98 A Humidity Sensor Abnormal
6
The printer detected that the humidity sensor was
abnormal.
98 A Protection During Transport
7
At power on the printer detected that the ink in a
cartridge is non-standard ink.
98 A Air Sensor Abnormal
8
Printer detected air sensor was abnormal when
suction was applied 3 times when the printer was
powered on for the first time for ink tank filling or
print head refreshing, but no air was detected.
99 A Ink Collection Unit Full Sensor Defective
0
The ink collection tank full sensor (a photo-sensor)
on the corner of the ink collection tank is not op-
erating.
• The temperature of the DRV board
(driver board) circuit is not within the
specified range: -13°C to 55°C
(11.2°F to 131°F)
• Print head temperature sensor was
detected as abnormal when the
printer was turned on without the
product number registered.
• Sensor connector loose, damaged,
or defective.
• Sensor defective
• Use only ink cartridges that are de-
signed for use with this printer.
• Never use re-filled ink cartridges.
• Cycle the printer off and on and try
again.
• If the problem persists, the print
head air sensors may be defective.
• Remove the ink collection tank and
inspect the sensor.
• Re-insert the tank and try again.
• If the problem persists, replace the
ink collection tank.
SC Error Codes
4
101