Ricoh Toscana-P1 J007 Service Manual page 40

5. Position the 500-Sheet Paper Tray paper tray where the printer will be set up.
6. Mount the cover on the paper tray.
7. Align the connection point holes in the bottom of the printer with the pegs of the paper tray
while you hold the printer as shown.
8. Slowly set the printer on top of the paper tray.
Load Paper in the Paper Feed Unit
1. Raise the paper tray slightly and pull it toward you to remove it.
2. Remove the paper tray cover.
3. Pinch the tabs of the bottom fence then slide it completely forward.
4. Fan a stack of paper to remove static cling.
5. Load the paper into the cassette.
6. Add paper until it as far as the load limit marks .
• To prevent paper jams, never load paper higher than the load limit mark.
7. Pinch the tabs of the bottom fence . Then move it to the edge of the stack.
8. Make sure the top of the stack is perfectly flat. Do this if the top of the stack bends upward:
9. Adjust the positions of the side fences and bottom fence.
Options
1
39