Ricoh Toscana-P1 J007 Service Manual page 152

Charge Width Setting Mj4: Simplex
1125 CHG:W1:MID:13
1127 CHG:W1:MID:14
1129 CHG:W1:MID:15
1131 CHG:W1:MID:16
Use this SP to set the pitch width of the charge applied to the MID area of the paper when
printing on glossy paper in the High Quality mode. Do this SP when mist build-up in the MID
area of glossy paper is causing the print heads to clog during printing in High Quality mode.
This SP setting is linked to the charge pitch tables (SP1200 to SP1231). The IDs are determined
by the temperature and humidity. There are 4 IDs associated with the SP numbers listed below:
• SP1125: ID1
• SP1127: ID2
• SP1129: ID3
• SP1131: ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj1 : Duplex
1132 CHG:W2:EDGE:1
1134 CHG:W2:EDGE:2
1136 CHG:W2:EDGE:3
1138 CHG:W1:EDGE:4
Use this SP to set the pitch width of the charge applied to the LE/TE on the back side of normal
paper during duplex printing in the High Speed (Draft) mode. Do this SP when mist build-up
near the leading and trailing edges on the back sides of the paper during duplex printing in the
High Speed (Draft) mode is clogging the print head nozzles. This SP setting is linked to the
charge pitch tables (SP1200 to SP1231). The IDs are determined by the temperature and
humidity. There are 4 IDs associated with the SP numbers listed below:
• SP1132: ID1
• SP1134: ID2
• SP1136: ID3
• SP1138: ID4
MID: Mj4: ID1
MID: Mj4: ID2
MID: Mj4: ID3
MID: Mj4: ID4
LE/TE: Mj1: ID1
LE/TE: Mj1: ID2
LE/TE: Mj1: ID3
LE/TE: Mj1: ID4
SP Tables
5
151