Ricoh Toscana-P1 J007 Service Manual page 159

5. Service Tables
1227 CHG:PITCH:D4
1228 CHG:PITCH:D5
1229 CHG:PITCH:D6
1230 CHG:PITCH:D7
1231 CHG:PITCH:D8
Use this SP to configure the charge ID table for printing on glossy paper in Quality mode. Do
this SP when mist build-up on glossy paper in use is clogging the print head nozzles. This setting
is linked to the charge pitch settings (SP1124 to 1131, SP1156 to 1163).
[0 to 0xffff ffff/0/1/---]
5
Set Charge Area 1
1232 CHG:AREA1:OHP
Use this SP to set the size of the leading and trailing edges of transparencies (OHP). Do this
setting when you want to adjust pitch amount of the charge applied to the leading and trailing
edge of transparencies for printing. The areas of the leading and trailing edges is shown below.
[5 to 255/0/1/mm]
1233 CHG:AREA1:F
Use this SP to set the size of the leading and trailing edges for the 1st side of any paper except
transparencies (OHP). Do this setting when you want to adjust pitch amount of the charge
applied to the leading and trailing edges on the 1st side any paper except transparencies. The
areas of the leading and trailing edges is shown below.
[5 to 255/0/1/mm]
1234 CHG:AREA1:B
Use this SP to set the size of the leading and trailing edges for the 2nd side (duplex printing) of
any paper except transparencies (OHP). Do this setting when you want to adjust pitch amount
of the charge applied to the leading and trailing edges on the 2nd side any paper except
transparencies for duplex printing. The areas of the leading and trailing edges are shown below.
[5 to 255/0/1/mm]
158
Mj4: 35% → 45% Lookup Table
Mj4: 45% → 55% Lookup Table
Mj4: 55% → 65% Lookup Table
Mj4: 65% → 75% Lookup Table
Mj4: More than 75% Lookup Table
Set Charge of Area 1 for LE/TE: OHP
Set Charge of Area 1 for LE/TE: Simplex: Any Other Than OHP
Set Charge of Area 1 for LE/TE: Duplex: Any Other Than OHP