Ricoh Toscana-P1 J007 Service Manual page 165

5. Service Tables
Use this SP to set the threshold time for the printer to remain idle for maintenance to execute
before the start of a print job. (Default: 7 Days). These threshold values are related to SP2115
to 2118.
[0 to 65535/0/1/sec.]
Note: These SP codes are still under development and will be used in the future but at the present
time changing these settings has no effect on the J007/J010 and J011.
Set Maintenance Method
2115 TH:ALM:MNT1
2116 TH:ALM:MNT2
5 2117 TH:ALM:MNT3
2118 TH:ALM:MNT4
Use this SP to select the type of maintenance that will be executed before the first print job begins
after the idle time threshold has elapsed.
1
* Air venting/filling is done if Bit 1 of SW8-3 is ON.
2
* Print head refreshing (flushing) is done if Bit 2 of SW8-3 is ON.
[0 to 65535/0/1/hours.]
Note:
• These SP codes are still under development and will be used in the future. But at the present
time changing these settings has no effect on the J007/J010 and J011.
Set Threshold for Venting During Printing
2200 TH:PRG:HUM11
2201 TH:PRG:HUM12
Use this SP to set the threshold value in the humidity table switches to the table for air venting
during printing.
• SP2200: Looks up the low humidity table (35%).
• SP2201: Looks up the high humidity table (65%).
[0 to 100/0/1/
164
After Time 1 Alarm (SP2111): Venting
After Time 2 Alarm (SP2112): Cleaning
After Time 3 Alarm (SP2113): Cleaning *
After Time 4 Alarm (SP2114): Cleaning *
35% Humidity
65% Humidity
o
C.]
1
2