Ricoh Toscana-P1 J007 Service Manual page 154

• SP1144: ID3
• SP1146: ID4
[0 to 255/0/1/0.1 mm]
1141 CHG:W2:MID:5
1143 CHG:W2:MID:6
1145 CHG:W2:MID:7
1147 CHG:W1:MID:8
Use this SP to set the pitch width of the charge applied to the MID area on the 2nd side of any
paper in any print mode during duplex printing except: normal paper in High Speed (Draft)
mode and glossy paper in High Quality Mode. Do this SP when mist build-up in the MID area
on the 2nd side of the paper in use is clogging the print head nozzles during duplex printing
with any paper in any mode, except: normal paper in High Speed (Draft) mode and glossy
paper in High Quality mode. This SP setting is linked to the charge pitch tables (SP1200 to
SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs associated with the
SP numbers listed below:
• SP1141: ID1
• SP1143: ID2
• SP1145: ID3
• SP1147: ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj3: Duplex
1148 CHG:W2:EDGE:9
1150 CHG:W2:EDGE:10
1152 CHG:W2:EDGE:11
1154 CHG:W1:EDGE:12
This SP is currently under development.
Use this SP to set the pitch width of the charge applied to the LE/TE on the 2nd side of paper in
future print modes (currently under development) during duplex printing. Do this SP when mist
build-up near the leading and trailing edges of the 2nd side is causing the print heads to clog.
MID: Mj2: ID1
MID: Mj2: ID2
MID: Mj2: ID3
MID: Mj2: ID4
LE/TE: Mj3: ID1
LE/TE: Mj3: ID2
LE/TE: Mj3: ID3)
LE/TE: Mj3: ID4
SP Tables
5
153