Ricoh Toscana-P1 J007 Service Manual page 147

5. Service Tables
[-128 to +127/FA/1/0.1 mm]
Note: This function is under development and is not available for the J007/J010 and J011
1013 REG:FD2:OHP:F
Use this SP code to adjust writing in the sub scan direction for transparencies (OHP). Do this
setting when it is necessary to fine adjust the line feed position.
[-128 to +127/FA/1/0.1 mm]
Note: This function is under development and is not available for the J007/J010 and J011
Paper Feed
1014 FDLEN:F
5
Do this SP adjust the amount of line feed for 1 scan line. Do this setting only if the line feed amount
cannot be adjusted on the user menu of the printer operation panel with "Adj. Paper Feed".
[-1000000 to +1000000/FA/1 μm]
1015 FDLEN:OFFSET
Use this SP to set the amount of line feed before the print head begins its 2nd pass during bi-
directional printing. Do this SP when it is necessary to correct color offset that occurs during bi-
directional printing.
[-128 to +128/FA/1/Vertical Encoded Pulse Count]
Carriage
101
ADJ:SIDEBOARD
6
Use this SP to set the reference position for installation of the right plate. Do this SP to correct the
alignment of the capping position with the carriage.
[-128 to +128/FA/1/0.1 mm]
Suction Vents
1017 PRGPORTS:R
146
Adjust Sub Scan Registration (OHP: 2nd Registration: FA)
Adjust Amount of Paper Feed (FA)
Adjust Amount of LF Offset in Sub Scan Direction
Adjust Sideboard (Carriage Home Position)
Adjust Position of Right Suction Vent DFU