Ricoh Toscana-P1 J007 Service Manual page 93

4. Troubleshooting
Message
Low ink.
Maintenance in pro-
gress...
Offline
Power Off/On
4
Call Service if error reoc-
curs
Printing...
Ready
Remove Misfeed
Bypass
Remove Misfeed
Duplex
Remove Misfeed
Output
Remove Misfeed
Top Cover
Remove Misfeed
Tray 1
Reset Duplex Unit correct-
ly
Reset the cartridge
92
Type
Error One or more of the ink cartridges is running low. Determine which
cartridge is low and obtain a replacement. The printer can be
used for a short time, but the cartridge should be replaced as
soon as possible.
Status The printer is busy cleaning or flushing the print head. Please wait.
Status Printer is offline. Push [Online] to set the printer for printing.
Error An error has occurred inside the printer.
Status A print job is printing.
Status The printer is ready and able to print.
Error Paper has jammed feeding from the bypass tray Remove the
jammed paper.
Note: This is the result of a registration sensor late error or regis-
tration sensor lag error.
Error Paper has jammed in the duplex unit. Open the duplex unit and
remove the jammed paper.
Note: This is the result of 1) Trailing edge sensor lag error during
either simplex or 2) Duplex printing, registration sensor late error
during duplex printing.
Error Paper has jammed at the output tray. Remove the jammed paper.
Error Paper has jammed under the top cover. Open the top cover and
remove the jammed paper.
Error Paper has jammed feeding from Tray 1 (registration sensor late
error). Remove the jammed paper.
Error The duplex unit is not installed correctly. Remove it and install it
again.
Error No ink cartridge is installed, or the ink cartridge is not installed
properly.
What It Means