Table of Contents
Advertisement
1. Installation
To clean all the printheads
1.
First, clean the print head:
1
• Push [Menu], select "Maintenance", push #Enter].
• Select "Head-cleaning" and push [#Enter].
• Push [Online] to return to standby mode.
2.
If this doe not solve the problem, flush the printhead:
• Push [Menu], select "Maintenance" and push [#Enter].
• Select "Head-flushing" and push [#Enter].
• Push [Online] to return to standby mode.
• These procedures consume ink.
• Flushing consumes more ink than cleaning.
• Flush the print head nozzles only if the cleaning (the first procedure) does not solve the problem.
To print a Nozzle Check Pattern
1.
Push [Menu], select "Maintenance", and push [#Enter].
2.
Select "Nozzle Check" and push [#Enter]
3.
Push [Online] to return to standby mode.
For more about how to use the Nozzle Check pattern to diagnose and correct problems, see Section
"4 Troubleshooting".
To restart an interrupted print job
Press the [Form Feed] key to start a print job again after you remove the cause of an error (paper jam, for
example). The [Job Reset] key flashes or lights and stays in this condition for errors. For more, see Section
"4. Troubleshooting".
To feed a sheet manually
1.
Set a sheet of paper in the bypass tray.
2.
Press the [Form Feed] key when the software application prompts you to do so.
22
Advertisement
Table of Contents
Troubleshooting
