Ricoh Toscana-P1 J007 Service Manual page 141

4. Troubleshooting
SP No. Menu Title
1164 CHG:HUMI:B
1165 CHG:TEMP:B
Do these settings when you want to change temperature or humidity column referenced to determine the
Charge ID for printing on Side 2.
The settings are adjusted in increments of 0.1°C from the settings of Side 1. The range is –128 to +127.
Example: Setting the Temperature for Side 2 2°C Higher (+2°C) than Side 1
Open SP1165 in the Engine Maintenance mode and set it to "20". If the temperature/humidity sensor
4
reads 25°C for Side 1, the machine will adjust this reading to 27°C then use 27°C to look up the Charge
ID for Side 2.
140
Calibrate Humidity Setting for Duplex
Calibrate Temperature Setting for Duplex
Meaning