Ricoh Toscana-P1 J007 Service Manual page 103

4. Troubleshooting
99 A Ink Collection Tank Full Error
2
At power on, the printer detected that the left ink
collection tank was full.
99 A High Voltage Leak
4
3
At power on or during a print job, a leak detection
signal was detected. The signal was triggered by
the accumulation of condensation or ink spillage
onto the transport belt.
99 A Vertical Motor Error
4
The vertical encoder input signal was judged to
be abnormal when the vertical motor was oper-
ating.
99 A No Input Signal from the Horizontal Encoder
6
No input signal from the horizontal encoder was
detected during operation of the horizontal motor.
99 A Input Signal from the Horizontal Encoder Abnormal
7
When the carriage moved to the right, the car-
riage did not stop at the HP. Or, the carriage scan
check failed.
102
• Replace the ink collection tank with
a new tank.
• Never attempt to clean the old tank
and reinstall it.
• Obey the local laws and guidelines
regarding disposal of items such as
the ink collection tank.
• This signal is triggered by the HVPS
due to an accumulation of conden-
sation or ink spillage onto the trans-
port belt.
• Clean the transport belt.
• Vertical encoder connector loose,
broken, or defective.
• SENC defective.
• Horizontal encoder sensor loose,
broken, or defective.
• Horizontal encoder film broken,
disconnected, or installed upside
down.
• HRB defective
• Horizontal encoder sensor loose,
broken, or defective.