Ricoh Toscana-P1 J007 Service Manual page 90

Menu/Menu Item
Key Repeat Enables/disables repetition of a key pushed and held down on the operation
panel.
Paper Feed Test* Feeds and ejects 1 blank sheet of paper to remove moisture inside the machine.
De-condensation* Feeds and ejects 3 blank sheets of paper to remove moisture inside the machine.
System
Auto Continue Determines how the printer handles a print job when the specified paper size
and type is not loaded in the tray.
Off: The job does not print if the specified paper size/type is not loaded in the
tray. The job will execute once the specified paper size/type is loaded.
On: The job prints even if the specified paper size/type is not loaded in the tray.
Sub Paper Size Determines whether to print on A4 paper if LT size paper is specified in the printer
driver, and vice versa.
Default: Off
Unit of Measure Determines the units of measure ("mm" or "in.") Default: mm
Energy Saver Switches the energy saving function on/off. When this function is on, the printer
will automatically shut down some of its functions automatically after it remains
idle for the prescribed amount of time.
The "E. Saver Timer" can be set for 5, 15, 30, 35, 60 min.
Once the printer enters the energy save mode, it will require some time to recover
full operation once it receives a print job.
Notify by Email* Determines whether a notification is sent to a specified email address when a
printer error occurs. Be sure to cycle the printer off/on after doing this setting.
Page Size Determines the default paper size. (The size selected automatically in the printer
driver.) Presents a variety of standard NA/EU paper sizes.
Ink CU Replace* Sets the ink storage counter after the ink collection unit is replaced.
Host Interface
I/O Timeout Determines how long the printer waits for the interface to respond. After the
specified time elapses, the printer can receive data from another interface. If the
specified time is too short, a timeout might occur while a data transfer is in pro-
gress. If this occurs, the print job will be interrupted by a new job from another
interface. Default: 15 sec.
Printer Display Summary
Function
4
89