Ricoh Toscana-P1 J007 Service Manual page 150

Use this SP to set the pitch width of the charge applied to the MID area of any paper in any
print mode except: normal paper in High Speed (Draft) mode and glossy paper in High Quality
Mode.
Do this SP when mist build-up in the MID area of the paper in use is clogging the print head
nozzles during printing with any paper in any mode, except: normal paper in High Speed (Draft)
mode and glossy paper in High Quality mode. This SP setting is linked to the charge pitch tables
(SP1200 to SP1231). The IDs are determined by the temperature and humidity. There are 4
IDs associated with the SP numbers listed below.
• SP1109: ID1
• SP1111: ID2
• SP1113: ID3
• SP1115: ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj3: Simplex
1116 CHG:W1:EDGE:9
1118 CHG:W1:EDGE:10
1120 CHG:W1:EDGE:11
1122 CHG:W1:EDGE:12
Use this SP to set the pitch width of the charge applied to the LE/TE of paper in future print modes
(currently under development). Do this SP when the paper in use is causing mist to build up near
the leading and trailing edges of the sheets and causing the print heads to clog. This SP setting
is linked to the charge pitch tables (SP1200 to SP1231). The IDs are determined by the tem-
perature and humidity. There are 4 IDs associated with the SP numbers listed below:
• SP1116: ID1
• SP1118: ID2
• SP1120: ID3
• SP1122: ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj3: Simplex
1117 CHG:W1:MID:9
LE/TE: Mj3: ID1
LE/TE: Mj3: ID2
LE/TE: Mj3: ID3
LE/TE: Mj3: ID4
MID: Mj3: ID1
SP Tables
5
149