Table of Contents
Advertisement
6.
Use a small screwdriver to depress the pawl [D] to release the left side of the cover.
7.
Lift up the ink cartridge compartment cover [E].
• The operation panel is connected by a fragile FFC (flat film connector).
• Do not disassemble the operation panel unless you are replacing it
8.
Turn over the cover and remove the screw [F].
• The operation panel of the J011 is fastened with two screws. Remove both screws.
9.
Push the latch [G] of the FFC connector away from the board to release the FFC.
10.
Carefully separate the tabs and slots [H] and [I] to disconnect the operation panel from the
cover
Reinstallation
To reconnect the FFC:
• Pull the FFC release away from the PCB.
• Insert the tip of the FFC into the slot with the GREEN side up.
Removing the Covers
3
59
Advertisement
Table of Contents
Troubleshooting
