Ricoh Toscana-P1 J007 Service Manual page 160

Set Charge Area 2
1235 CHG:AREA2:B
Use this SP to set the size of the MID area of transparencies (OHP).
Do this setting when you want to adjust pitch amount of the charge applied to the MID area of
transparencies for printing. The MID area is shown below.
[5 to 255/0/1/mm]
1236 CHG:AREA2:F
Use this SP to set the size of the MID on the 1st side of any paper except transparencies (OHP).
Do this setting when you want to adjust pitch amount of the charge applied to the MID area on
the 2nd side of any paper other than transparencies. The MID area is shown below.
[5 to 255/0/1/mm]
1237 CHG:AREA2:B
Use this SP to set the size of the MID on the 2nd side of any paper except transparencies (OHP)
for duplex printing. Do this setting when you want to adjust pitch amount of the charge applied
to the MID area on the 2nd side of any paper other than transparencies for duplex printing. The
MID area is shown below.
[5 to 255/0/1/mm]
Set Charge of Area 2 for MID: OHP
Set Charge of Area 2 for MID: Simplex: Any Other Than OHP
Set Charge of Area 2 for LE/TE: Duplex: Any Other Than OHP
SP Tables
5
159