Ricoh Toscana-P1 J007 Service Manual page 155

5. Service Tables
This SP setting is linked to the charge pitch tables (SP1200 to SP1231). The IDs are determined
by the temperature and humidity. There are 4 IDs associated with the SP numbers listed below:
• SP1148: ID1
• SP1150: ID2
• SP1152: ID3
• SP1154: ID4
[0 to 255/0/1/0.1 mm]
1149 CHG:W2:MID:9
1151 CHG:W2:MID:10
1153 CHG:W2:MID:11
1155 CHG:W1:MID:12
5
This SP is currently under development.
Use this SP to set the pitch width of the charge applied to the MID area of the 2nd side of paper
in future print modes (currently under development) during duplex printing. Do this SP when mist
build-up in the MID area is clogging the print head nozzles. This SP setting is linked to the charge
pitch tables (SP1200 to SP1231). The IDs are determined by the temperature and humidity.
There are 4 IDs associated with the SP numbers listed below:
• SP1149: ID1
• SP1151: ID2
• SP1153: ID3
• SP1155: ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj4: Duplex
1156 CHG:W2:EDGE:13
1158 CHG:W2:EDGE:14
1160 CHG:W2:EDGE:15
1162 CHG:W1:EDGE:16
Use this SP to set the pitch width of the charge applied to the LE/TE on the 2nd side of glossy
paper for duplex printing in the High Quality mode. Do this SP when the mist build-up near the
leading and trailing edges on the 2nd side of glossy paper is causing the print heads to clog
154
MID: Mj3: ID1
MID: Mj3: ID2
MID: Mj3: ID3
MID: Mj3: ID4
LE/TE: Mj4: ID1
LE/TE: Mj4: ID2
LE/TE: Mj4: ID3
LE/TE: Mj4: ID4