Ricoh Toscana-P1 J007 Service Manual page 153

5. Service Tables
[0 to 255/0/1/0.1 mm]
1133 CHG:W2:MID:1
1135 CHG:W2:MID:2
1137 CHG:W2:MID:3
1139 CHG:W1:MID:4
Use this SP to set the pitch width of the charge applied to the MID area on the 2nd side of normal
paper (excluding the LE/TE) for duplex printing in the High Speed (Draft) mode. Do this SP
when mist build-up in the MID area on the back sides of the paper during duplex printing in the
High Speed (Draft) mode is clogging the print head nozzles. This SP setting is linked to the
charge pitch tables (SP1200 to SP1231). The IDs are determined by the temperature and
humidity. There are 4 IDs associated with the SP numbers listed below.
5
• SP1133: ID1
• SP1135: ID2
• SP1137: ID3
• SP1139: ID4
[0 to 255/0/1/0.1 mm]
Charge Width Setting Mj2: Duplex
1140 CHG:W2:EDGE:5
1142 CHG:W2:EDGE:6
1144 CHG:W2:EDGE:7
1146 CHG:W1:EDGE:8
Use this SP to set the pitch width of the charge applied to the LE/TE on the 2nd side of any paper
in any print mode during duplex printing except: normal paper in High Speed (Draft) mode and
glossy paper in High Quality Mode. Do this SP when mist build-up up near the leading and
trailing edges on the 2nd side is clogging the print head nozzles during duplex printing with
any paper in any mode, except: normal paper in High Speed (Draft) mode and glossy paper
in High Quality mode. This SP setting is linked to the charge pitch tables (SP1200 to SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs associated with the
SP numbers listed below.
• SP1140: ID1
• SP1142: ID2
152
MID: Mj1: ID1
MID: Mj1: ID2
MID: Mj1: ID3
MID: Mj1: ID4
LE/TE: Mj2: ID1
LE/TE: Mj2: ID2
LE/TE: Mj2: ID3
LE/TE: Mj2: ID4