Ricoh Toscana-P1 J007 Service Manual page 148

Use this SP to adjust the venting position of the right air vent. Do this SP after it has been deter-
mined that the ink is not venting at the center of the right ink suction vent.
[-128 to +128/FA/1/0.1 mm]
1018 PRGPORS:L
Use this SP to adjust the venting position of the left ink suction vent. (Do this SP after it has been
determined that the ink is not venting at the center of the left ink suction vent.
[-128 to +128/FA/1/0.1 mm]
Charge Width Setting Mj1: Simplex
1100 CHG:W1:EDGE:1
1102 CHG:W1:EDGE:2
1104 CHG:W1:EDGE:3
1106 CHG:W1:EDGE:4
Use this SP to set the pitch width of the charge applied to the LE/TE of normal paper for printing
in the High Speed (Draft) mode. Do this SP when mist build-up near the leading and trailing
edges of the paper in use during printing in the High Speed (Draft) mode is clogging the print
head nozzles. This SP setting is linked to the charge pitch tables (SP1200 to SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs associated with the
SP numbers listed below:
• SP1100: ID1
• SP1102: ID2
• SP1104: ID3
• SP1106: ID4
[0 to 255/0/1/0.1 mm]
1101 CHG:W1:MID:1
1103 CHG:W1:MID:2
1105 CHG:W1:MID:3
1107 CHG:W1:MID:4
Use this SP to set the pitch width of the charge applied to the MID area of normal paper (ex-
cluding the LE/TE) for printing in the High Speed (Draft) mode. Do this SP when mist build-up
Adjust Position of Left Suction Vent DFU
LE/TE: Mj1: ID1
LE/TE: Mj1: ID2
LE/TE: Mj1: ID3
LE/TE: Mj1: ID4
MID: Mj1: ID1
MID: Mj1: ID2
MID: Mj1: ID3
MID: Mj1: ID4
SP Tables
5
147