Ricoh Toscana-P1 J007 Service Manual page 70

• If you push too hard, the bracket may release suddenly from the frame and the edge of the cover
may shear components from the control board.
4. Touch a metal surface before you touch the control board.
5. Remove the control board [C] (
6. The NVRAM is on the bottom of the board. Turn the board over and lay it on a flat surface.
If the control board is being replaced:
1. Pull the NVRAM from the control board removed from the printer.
2. Install the NVRAM on the new control board.
x8, x6).
Component Removal
3
69